Card Exchange - Red & Black Daisies

I started with the plastic daisy accent and built the cards around that.  I added a silver cardstock scallop behind the daisy and held all this together with a black mini brad.

The designer paper is Stampin Up. I chose it for the black and white circles.  I wrapped a piece of grey twine around this layer and taped it in place at the back.  This was then adhered to the front of the black card base. I added the daisy accent in top left hand corner over the twine.

The greeting is color printed circle in red layer over a red Modern Label punchie. This was adhered with 3D foam tape.  A quarter sheet white blank insert was added.

This is very similar supplies with the opposite color scheme based on the black daisy.  I chose the portrait orientation this time. 

The twine was wrapped on the diagonal off each corner of the designer paper and knotted to the front then taped to the back.  The same paper was used here.This layer was adhered to a Real Red card base.

The scallop circle is Real Red as well and layered the same way.  Adhered to the top left hand corner.

The circle greeting is color printed in black and punched with the 1.25 inch circle punch. The Real Red circle is punched with the 1.38 inch then adhered to the back of the greeting circle.

This this then adhered to the card front with 3D foam tape.  

A blank insert and a white envelope rounds out the card.

These are off in the mail tomorrow.