Ready 2 Go All Occasion Stack Kit - Set 03

Angled Rectangle

I started with a grey card base.

I chose designer paper by Creative Imaginations - Art Warehouse - Danielle Johnson cut to 4.00x5.25 inches. I laid the designer paper onto the card front at an angle then adhere it.  I trimmed the excess to the card edge with scissors.

I cut the dark green Decorative Label punchie in half crosswise then trimmed the points off with scissors.  I offset these behind the greeting.   The accent was then adhered to the card front with 3D foam tape.

Split Square

I cut a 4 inch square of designer paper into 2 equal triangles by cutting top left hand corner to opposite corner with a paper cutter.   These were glued to the card front aligned to the top and the bottom.   That leaves a nice band of card color on the diagonal.

I wrapped a length of white grosgrain ribbon around the card front and knotted on the front.  Trimmed the ends on the slant.

I assembled the flower accent by putting the small flower then the large flower onto the brad.  Press the prongs apart on the back.

I added the 3D foam tape to the back of the flower accent and adhered it to the card front.

A quarter sheet insert is glued to the right hand side.

 Masculine DSP Split

I selected a kraft colored card.

I chose a designer paper by Creative Imaginations featuring stars.  I cut it to 4.00 x 5.25 then cut again at 3.5 inches.  Turned the small over and tape to 2 pieces back together.

Wrapped the designer paper layer with ginger grosgrain ribbon and taped the ends to the back.  Adhered to the card front.

Assemble the star accent and adhered to the front with 3D foam tape.