Sewing Project - Picnic Placemats - QAYG Blues

Another set of scraps put to good use.

This time I chose all blue fabric. 

I created the navy blue zipper insert/pocket on the right hand side first. 

I chose a piece of grey flannel and chose to make the size of the placemat this time. 12.5 x 17.5 inches.

I sewed on the strips of fabric starting from the right hand side close to where the pocket ended. I continued till I got to the left hand side. 

I created a tie from the polka dot fabric.  The back is a pin striped cotton poly fabric which I cut the size of the front.  I pinned the ties opposite the pocket and sewed all the way around leaving a space open to turn it right sides out.   I trimmed the fabric in the corners, turned it and pressed it nicely.  I put a line of top stitching very close the edge which closed the space I left open earlier.

I chose my wavy decorative stitch to quilt the 2 layers together 3 time across the placemat.

Another done!

Sewing Project - Book Sleeve - Pin Stripe

I chose 100% cotton fabric from a men's shirt for the outside of this bag/sleeve.  Really nice crisp fabric.  I chose black thread for this project.

I created some cotton poly fabric from some of squares I got from the box of fabric donated to me.  I used 4 squares and sewed them together staggering the seams and then trim the excess and added it back to the length to get what I needed.  

I cut all my layers the same size 12 inches wide and 19 inches tall.  Pin Stripe outer fabric, flannel, and black taupe patterned fabric I made. The stitching I did to attached the flannel to the outer fabric was a rectangle on the front and back about 2 inches away from the edge.

I created my handles from the cotton poly fabric squares of the patterned fabric.  I cut a stripe then folded the edges into the center then ironed it half again.  I placed 4 lines of stitching both outer edges and then 2 in the middle. The handles measure 1.25 inches wide and were cut to 12 inches long.

Tacked the handles and black elastic in place then placed the bags one inside the other and sewed the top edges together leaving a gap to turn it inside out. Turned right sides out and ironed flat then pushed the lining into the bag.  I top stitched the top very close to the edge then added another line of stiching 1/2 inch from the top.

I chose a beige button but I would have preferred a gold one.

For information on the "My Bag" Line

Grey Pinstripe Smock Apron with Red accents

I started with a Ralph Lauren grey pinstripe 16.5/36 L men`s shirt.

I decided on red bias tape around the neckline and the arm holes.

I used one of the long sleeves for the patch pockets onto which I added red bias tape on the slant edge.

I used the other long sleeve for the waist ties. I cut the stripe 2 1/4 inches wide and 80 inches long. I ironed the sides into the center then ironed it in half.  I top stitched the ties with red thread and created square ends.  This fabric would have been too heavy to turn a tied inside out.

















It includes my standard features of a hanging loop at the back, tacked tied to allow them to adjust as needed, reinforced stress points on the patch pockets and the ties long enough to tie in front.