Ready 2 Go Christmas Card Kit - Set 10

Working on card kits for my stack card class on November 4th.

I started with a red card in the landscape orientation.

I added a piece of red plaid metallic paper which was cut to 4.00 x 5.25 inches and adhered to the front

I added the Christmas green tree brad to the gold foil NOEL label cut with the Stampin Up Apothecary Framelits. I made a hole with a push pin, inserted the brad and pressed the prongs apart at the back. I added 2 pieces of 3D foam tape and adhered it to the card front.

The gold fabric snowflake was adhered in the top left hand corner with a Bling Zot.

I started with a red card in the portrait orientation.

I cut a layer of green card stock to 4.00 x 5.25 inches.  I added a length of red cotton ribbon aligned left of center and taped the ends to the back. The layer was then adhered to the card front.

The musical holly accent square as adhered to the card front over the ribbon with 4 pieces of 3D foam tape.

I added a greeting in the bottom right hand corner.  It was color printed and punched out with the Stampin Up Modern Label punch.

It was adhered to the card front with 3D foam tape.

You can check out my R2G card kits on the tab above.

R2Go Christmas Stack - Gold, Red, Green

I cut the Merry Christmas layer with one of the thinlets from the Sizzix Square set which is 3.75 inches square.  I cut the Christmas green layer to 4 inches square.  These are adhered together. I used a push pin to create the 2 holes for the brads - Star Glitter and Green Pine tree brads.

I spattered the red card base with gold Gleams acrylic paint and let it sit till it was dry - a couple hours. Once dry I wrapped a piece of ivory and gold metallic organza ribbon around the card front and taped the ends to the card front under where the greeting will cover.

I cut the 3D foam tape square into 4 pieces and placed them in the four corners.  I then adhered the greeting square over the taped ribbon ends leaving even border top and bottom.

Glue the quarter sheet insert inside.

I cut the metallic gold NOEL layer with the Tim Holtz Bracket die.

I used a push pin to create the hole in the middle of the O in NOEL and pushed the brad through and spread the prongs apart on the back. 
Inny Outie Bow - Put one end of the ribbon through the left hand hole then repeat with the other end through the right hand hole. Cross the ends on the back and reinsert the ends through the opposite hole from the back. Pull gently to take up the slack. 

I cut the 3D foam tape square in 4 and put on on each corner.  I then adhered the NOEL layer to the front of the green card.

Trimmed the ends of the ribbon with scissors and glued the quarter sheet insert on the inside of the card.

Card Club - November - Christmas Tree DSP Split

This is a designer paper split.  I cut the DSP at 4.00x 5.25 inches.  I printed the greeting on the back of the top half then cut the paper at 3.5 inches from the bottom.  When I turned the smaller piece over there was the greeting.  I added a metallic gold and kraft ribbon over the join and taped the ends to the back of the layer.  This was then adhered to the green card front.  I added a green Christmas tree brad on the right hand side which holds everything together. 







The DSP had two color variations some with green trees and the other with grey trees. I chose a grey card and I had to come up with a different accent for the grey paper so I chose a silver snowflake held in place with a tiny gold brad.